What Are Clamps For In Hisencn Repair Kit?
Repair kit Airfilter housing clamp
Volvo 200, 300, 700, 900, 850, S70, V70 (-00), S90, V90 (-98)
24.11.2021
Instructions for repairing the closing clamps of the air filter box with the SKANDIX repair kit 1079199. Most anybody who has driven Volvo 700/900 series Volvos for a longer time knows the trouble: The clamps for the cover of the air filter box simply tear off at some point. The air filter housings are no longer bachelor as new parts and up to now yous had to brand do with unsightly solutions such as cable ties or bounden wire. We now offer an elegant repair solution that is almost identical to the original and will last for a long time. The example vehicle is Volvo 945 with B230FT turbo engine. On the models without turbo the air filter box is mounted on the left side of the vehicle, but the procedure is basically the aforementioned. In other Volvo Models, for example the 240 or 850 you take to place the right position for the clamp at the airfilter housing. Therefore y'all have to consider the expansion of the clamp. In a Volvo 850 for example the clamp has it`s best position directly nether the socket of the original clamp.
For installation, ii 5mm holes must be drilled into the air filter box per lock, for which it must be removed.
Unlock and remove the plugs from the air mass meter and the crankcase ventilation, put the line aside.
Release the clamps from the air mass meter and put the air flow meter and the clamps safely aside besides.
Remove the cover of the air filter box and remove the air filter insert.
Unscrew the screw of the air filter box from the retaining bracket on the longitudinal beam.
Lift the air filter box slightly on the engine side and pull it out of the inner mudguard towards the engine, then remove it upwards.
At the clamp positions where, as in the flick, in that location is a bar under the clamp, information technology must be ground away in the lower area up to approx. 22mm under the upper edge of the air filter box bottom role.
The holes for the base of operations of the new bracket must be placed centrally under the old snap-in surrounds (see also Fig. ane).
Get-go, only the lower pigsty should be drilled. Here the hole centre 49-51 mm beneath the upper edge of the air filter base of operations should be drilled.
Now spiral the base of the clench only in the lower pigsty and use the smaller of the enclosed washers on the inside for this.
Align and tighten the clamp vertically. Just then drill the upper pigsty through the housing. The base of the clench then serves as a template and the drill cannot exist distorted.
Now spiral and tighten the upper screw with the large washer on the inside of the air filter box.
When all defective clamps have been replaced in this way, the air filter box can exist reassembled.
This is a good opportunity to make clean the air filter box correct away and to install a new air filter insert!
Now the exchange of the air filter insert is again hands possible as with the original office and there is no more need for complicated handling with emergency solutions!
- All notes serve only as an example and do not supplant the workshop instructions of the auto manufacturers! All data is supplied without guarantee!
- Installation guide: Repair kit Airfilter housing clamp
24.11.2021, 498 KBytes
Additional information...
- 1079199: Clamp, Airfilter housing Repair kit
Source: https://www.skandix.de/en/documents/installation-guide/repair-kit-airfilter-housing-clamp/3000565/
Posted by: blackmononeins.blogspot.com
0 Response to "What Are Clamps For In Hisencn Repair Kit?"
Post a Comment